Getting a new door will make your property look good and secure. However, no matter how nicely a new door looks, wrong measurements will make everything wrong. Incorrect dimensions will cause delays, bad installation and additional cost. So whatever door you are going to choose – you have to measure everything accurately to order and install a new door correctly. The manufacturer of specialty doors in Victoria Australia recognises the necessity of choosing door solutions according to your requirements.
Prepare Required Tools for Measuring
Before starting, you will need a quality tape measure, a pencil, some paper and spirit level. It would be better to have a helper during large openings measuring. Write down all of your measurements immediately to avoid mistakes. It is recommended to measure a few times and double-check your results before ordering. Even small errors may affect your door installation especially if you will work with custom sizes or old door frames.
Find Out the Width and Height
If you are installing a new door with retaining old frame, you should measure door width from the top, middle and bottom of the door panel. You will need to measure the height of the door panel from the both sides and if it is necessary – from the center. For full door unit installation, you may need to measure a rough opening. Rough opening is a structural opening that will accommodate a door frame. Everything will depend on whether you are going to change only door panel or entire unit. Do not think that opening is square even if you are dealing with an old property. Make all the required measurements and compare them with manufacturers specifications before ordering.
Find Out Door Thickness and Frame Depth
Width and height are not the only dimensions you should pay attention to. Find out door thickness and frame depth and check if a chosen door is compatible with your wall, hinges and lock hardware. It is especially necessary to measure all these parameters if you want to buy Wooden flush panel doors for your interior or a replacement door that will fit existing frame. You can ask for help from the manufacturer if you do not know what dimensions you will need for your product.
Inspect the Frame and Check Floor Clearance
Before finishing with your measurements, make sure that the frame is level, plumb and has good structure. Warped frame or uneven floor will affect your door opening and closing process. Check finished floor height taking into account planned tiles, carpets or other flooring. Adequate clearance will help to avoid any troubles with floor scratching. External doors also need weather protection and threshold details to be protected from draughts and water penetration. You may consider Specialty Doors when looking for custom wooden external doors or other door solutions suitable for your property design and requirements.
Consider Door’s Purpose and Design
There are different requirements for different rooms. Bedroom or living room may need some door with special focus on appearance and privacy. Offices should have some soundproofing. For this purpose, you may consider Acoustic doors in Melbourne depending on the project acoustic performance requirements. Take into account door’s material, finish, destination place, maintenance requirements and hardware compatibility when choosing a door. Measuring should be performed together with product selection.
Make Your Door Project Easier With Specialty Doors
Proper measuring before ordering may help you to avoid installation problems and additional costs. Always check required dimensions and installation conditions before buying a door, and turn to professionals if your opening has some structural deviations or you will need some structural changes. Specialty Doors is a custom door manufacturer located in Victoria, Australia. They provide doors all around Australia including Melbourne, Sydney, Adelaide, Gold Coast and Geelong. Whatever project you have – renovation or construction – Specialty Doors will help you to explore door solutions suitable for your design and functional requirements.